Abstracts – Browse Results

Search or browse again.

Click on the titles below to expand the information about each abstract.
Viewing 13 results ...

Ahmad Shazali, A S and Tahar, K N (2019) Virtual 3D model of Canseleri building via close-range photogrammetry implementation. International Journal of Building Pathology and Adaptation, 38(01), 217–27.

  • Type: Journal Article
  • Keywords: UAV; Accuracy; 3D model; Close-range photogrammetry;
  • ISBN/ISSN: 2398-4708
  • URL: https://doi.org/10.1108/IJBPA-02-2018-0016
  • Abstract:
    The current technique used to measure construction is the conventional total station method. However, the conventional method is time-consuming and could not be used to create a photo-realistic three-dimensional (3D) model of an object. Furthermore, the Canseleri building is located at a slope. The paper aims to discuss this issue. Design/methodology/approach The aim of this study is to assess the geometric accuracy of a 3D model using unmanned aerial vehicle (UAV) images. There are two objectives in this study. The first is to construct a 3D model of the Canseleri building using UAV images. The second objective is to validate the 3D model of the Canseleri building based on actual measurements. Findings The close-range photogrammetry method, using the UAV platform, was able to produce a 3D building model. The results show that the errors between the actual measurement and the generated 3D model were less than 4 cm. The accuracy of the 3D model achieved in this study was about 0.015 m, compared to total station measurements. Originality/value Accuracy assessment was done by comparing the estimated measurement of the 3D model with the direct measurement. The differences between the measured values with actual values could be compared. Based on this study, the 3D building model gave a reliable accuracy for specific applications.

Amadi, A and Higham, A P (2019) A cost trajectory to environmentally adaptive building construction in wet humid settings. International Journal of Building Pathology and Adaptation, 38(01), 68–88.

Ashdown, M M, Crawley, J, Biddulph, P, Wingfield, J, Lowe, R and Elwell, C A (2019) Characterising the airtightness of dwellings. International Journal of Building Pathology and Adaptation, 38(01), 89–106.

Crawley, J, Biddulph, P, Wingfield, J, Ashdown, M, Lowe, R and Elwell, C (2019) Inferring the as-built air permeability of new UK dwellings. International Journal of Building Pathology and Adaptation, 38(01), 3–19.

Djebbar, K E, Salem, S and Mokhtari, A (2019) Assessment of energy performance using bottom-up method. International Journal of Building Pathology and Adaptation, 38(01), 192–216.

Erkoreka, A, Flores-Abascal, I, Escudero, C, Martin, K, Millan, J A and Sala, J M (2019) Flat roof hygrothermal performance testing and evaluation. International Journal of Building Pathology and Adaptation, 38(01), 148–75.

Flood, C and Scott, L (2019) Thermal analysis and post construction verification. International Journal of Building Pathology and Adaptation, 38(01), 51–67.

Gupta, R, Gregg, M and Cherian, R (2019) Developing a new framework to bring consistency and flexibility in evaluating actual building performance. International Journal of Building Pathology and Adaptation, 38(01), 228–55.

Hamidane, H, Ababneh, A, Messabhia, A and Xi, Y (2019) Modeling of chloride penetration in concrete structures under freeze-thaw cycles. International Journal of Building Pathology and Adaptation, 38(01), 127–47.

Ibraheem, Y, Piroozfar, P A, Farr, E R and Ravenscroft, N (2019) Methodological evaluation of Integrated Façade Systems. International Journal of Building Pathology and Adaptation, 38(01), 107–26.

Li, M, Allinson, D and Lomas, K (2019) Estimation of building heat transfer coefficients from in-use data. International Journal of Building Pathology and Adaptation, 38(01), 38–50.

O’Connell, S, Reynders, G, Seri, F, Sterling, R and Keane, M M (2019) A standardised flexibility assessment methodology for demand response. International Journal of Building Pathology and Adaptation, 38(01), 20–37.

Rogage, K, Clear, A, Alwan, Z, Lawrence, T and Kelly, G (2019) Assessing building performance in residential buildings using BIM and sensor data. International Journal of Building Pathology and Adaptation, 38(01), 176–91.